Thoughts on interfacing piezo vibration sensor
Some time ago, I purchased a MiniSense 100 Vibration sensor. I probably had some project in mind, but it happened that it dived into drawer among other “to do” things. I thought it’s time to try a few things with it. Piezo sensor MiniSense 100 is very sensitive with a pretty good frequency response and is linear (±1%). As you can see, high sensitivity is achieved with a 0.3-gram inertial mass at the end of the film. As there is a hole in the mass, you probably can screw in an additional mass and increase sensitivity even further. Probably there is no need to explain where such a sensor would be helpful. These could be vibration/ motion sensors, impact sensors, and other areas where motion and acceleration are involved. Usually, sensitivity is 1V/g. Where g is standard gravity or standard acceleration due to free fall and is equal to 9.80665m/s2. As a mechanical device, it also has a resonant frequency of 75Hz. At this point, sensitivity reaches 5V/g.